First, the engine lubricant quantity check
Park the vehicle on a level surface. Pull out the vernier scale to check the oil quantity. If the oil is bright within the two lines “F” and “L”, it is within the normal range, if it is lower than the “L” position. The oil of the specified model should be added, and the liquid level after refueling should not be higher than the “F” position.
Second, the engine coolant level check
Never open the radiator cover while the engine is in a hot state, otherwise it may be burnt by splashed coolant or high temperature steam. After the engine is cooled, check that the liquid level of the coolant should be between the full and low positions. Otherwise, the same coolant, distilled water or purified water (no mineral water) should be added. The liquid level after adding water should not exceed the full level. Bit. If the coolant is found to decrease rapidly in a short period of time, check the cooling system for leaks or check it at the service station.
Third, the brake fluid level inspection
The brake fluid is also normal between high and low. If the brake fluid is close to the lower limit or lower than the lower limit, it indicates that there may be leakage in the system or the brake shoe is excessively worn. It should be repaired at the service station in time.
When adding brake fluid, pay attention to adding the same type of brake fluid to prevent damage to the cup, and pay attention to protect the paint to prevent corrosion of the paint surface.
Fourth, the clutch master pump liquid level inspection
If the clutch liquid level is between high and low liquid level, it means normal. If it is lower than the standard line, it may be damaged by the master pump or the pump bowl. In the engine running state, there will be a phenomenon that the gear is difficult or impossible to be geared. Please go to the nearest service station for repair.
Five, battery maintenance inspection
Check whether the battery is firmly fixed. The electrolyte should be between the upper and lower limits. When the line is close to the lower line, add electrolyte or distilled water to the high line. Keep the battery positive and negative cable in good contact and keep the battery clean and dry. If the vehicle is placed for a long time, remove the positive and negative cables of the battery, and re-wire the engine for about 20 minutes after about half a month. If the power is obviously insufficient, it should be charged in time.
Sixth, tire inspection
The tire pressure should be checked at room temperature every month. If it is lower than the normal standard, the tire pressure should be replenished in time. The air pressure should not be too high or too low, otherwise it will affect the safety of driving.
Check the cracking of the tires and replace the tires in time when there is a safety hazard.
When using tires, the model should be the same.
Seven, belt inspection
When starting the engine or driving the vehicle normally, the belt sounds. One case is that the belt has not been checked and adjusted for a long time, and it can be adjusted according to normal standards. In another case, the belt is aging and needs to be replaced.
8. Checking the air filter If the air filter is too dirty, it may cause the engine to work poorly, the fuel consumption is too large, and the engine may be damaged. When the air filter is checked, if the dust is found to be less, the blockage is lighter and the high pressure air can be used from the inside. Blow out and continue to use. The dirty air filter should be replaced in time.
Nine, spark plug inspection
The normal spark plug insulation ceramic is intact. There is no leakage and leakage phenomenon. When the spark plug gap is 0.8+-0.0mm, the spark is blue and strong. If an abnormality is found, adjust the gap or replace the spark plug.
X. Checking the fuel filter If the oil supply is found to be unsatisfactory, check if the fuel filter is clogged. If the foreign matter is clogged, replace it in time.